Lancom Systems LS61465 Información técnica descargar pdf (Pagina 127)

LANCOM ES-2126+ und LANCOM ES-2126P

쮿 Chapter 5: Operation of CLI Management

126

5 Operation of CLI Management

5.1 CLI Management

Refer to Chapter 2 for basic installation. The following description is the brief

of the network connection.

-- Locate the correct DB-9 null modem cable with female DB-9 connector.

Null modem cable comes with the management switch. Refer to the

Appendix B for null modem cable configuration.

-- Attach the DB-9 female connector to the male DB-9 serial port

connector on the Management board.

-- Attach the other end of the DB-9 cable to an ASCII terminal emulator

or PC Com-1, 2 port. For example, PC runs Microsoft Windows

HyperTerminal utility.

-- At “Com Port Properties” Menu, configure the parameters as below:

(see the next section)

5.1.1 Login

The command-line interface (CLI) is a text-based interface. User can

access the CLI through either a direct serial connection to the device or a

Telnet session. The default values of the managed switch are listed below:

Username: admin

Password: admin

After you login successfully, the prompt will be shown as “#“ if you are the

first login person and your authorization is administrator; otherwise it may

show “$“. See the following two figures. The former means you behave as

an administrator and have the access right of the system. As to the latter,

it means you behave as a guest and are only allowed to view the system

without the permission to do any setting for this switch.

Baud rate 57600

Stop bits 1

Data bits 8

Parity N

Flow control none

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 243 244

Sin comentarios

Lancom Systems LS61465 Información técnica Pagina 127